SPL-3-9 Lever Nut Wire Connector - 3 In 9 Out Compact Splicing Terminal

A SPL-3-9 lever nut connector lets you split one supply into up to nine separate runs from a single compact block — no screwdriver or crimp tool needed.

What it's for

CCTV installers use these in junction boxes and ceiling voids to branch a single incoming cable (power or control) out to multiple cameras or accessories, rather than fitting several smaller connectors. The 3 input / 9 output layout means you feed in up to three conductors and distribute across nine outputs from one point.

How the lever works

Lift the lever, push in the stripped wire, press the lever back down — the connection is made and held mechanically. There's no stripping tolerance to get wrong twice: because it's reusable, you can release the lever and re-terminate if you've run the wrong cable or need to add a branch later.

What to check before buying

• Rated 250V, up to 32A — fine for typical lighting and low-voltage control wiring, but confirm your circuit load sits within that.
• Takes solid, stranded and flexible conductors, so it suits most cable types found in CCTV and lighting runs.
• Flame-retardant nylon housing with tinned copper conductors inside, for a durable, insulated connection point.

Good for lighting circuits, control panels and any junction box where several cable runs need to meet at one tidy connection.