Wire to BNC Female Plug Screw Terminal Connector CCTV Adapter

This adapter turns bare, stripped wire into a standard BNC female connection for CCTV and AV video runs. It's a screw-terminal solution, so there's no soldering iron needed on site.

What it does

A 2-pin screw terminal block accepts stripped wire ends and clamps them down securely with a screwdriver. The BNC female end then mates with any BNC male plug — camera leads, DVR inputs, monitor cables and similar CCTV or AV equipment.

Where it's useful

If you're running your own cable and need to terminate it to BNC without crimping tools or solder, this bridges that gap. It suits analogue camera installs, general AV setups, and any job where a quick, mechanical connection beats a soldered one.

What to check before buying

• Confirm the far end of your cable is genuinely bare/stripped wire, not a pre-fitted connector — this adapter is built for that terminal-block input.
• Check the equipment you're connecting to (DVR, camera, monitor) uses a BNC male plug, since that's what this female end is designed to mate with.
• The screw terminal has 2 pins, so it suits a simple two-conductor video connection rather than more complex wiring.

Installation

No soldering is required — just strip the wire, seat it in the terminal block, and tighten the screws for a secure signal connection.