Product Description
The PCT-104 is a 4-port push wire connector for joining or splitting conductors inline, without screw terminals or a crimping tool. It's built for CCTV power runs and low-voltage wiring where you need a quick, secure joint inside a junction box or enclosure.
Each of the four ports takes a solid or stranded copper conductor from 1.5mm² to 4mm² and uses a push-in spring clamp: strip the wire, push it in, done. That range covers most CCTV power cable and lighting/control circuit wiring you'll meet on a typical install.
It's rated up to 250V, so it can be used across low-voltage CCTV feeds and mains-voltage wiring within that rating. The housing is transparent, which matters more than it sounds — you can see each conductor is fully pushed home before you close the box up, rather than guessing.
Where it fits
- Joining or extending CCTV camera power cable back to a PSU
- Branching a lighting or control circuit without a new back box
- General inline termination in junction boxes, enclosures or rack cabinets
Before you buy
Check your conductor size falls within 1.5–4mm² and that the connector's port count (4) matches how many wires you need to join at that point — it isn't a distribution block for more than four conductors.
Technical Specifications
Frequently Asked Questions
What size cable can I use with the PCT-104?
Solid or stranded copper conductors from 1.5mm² to 4mm² fit the push-in ports.
Do I need any tools to wire it up?
No — it uses a push-in spring clamp, so you just strip the wire and push it into the port.
What voltage is it rated for?
It's rated up to 250V, covering both low-voltage CCTV wiring and mains-rated circuits within that limit.
Can I see if the wire is properly connected?
Yes, the housing is transparent so you can check each conductor is fully inserted before closing the enclosure.
