Product Description
This block takes one 12V DC or 24V DC power feed and splits it into six outputs, so a single PSU can run several CCTV cameras from one junction point.
What it does
- 2 input terminals, 6 output terminals — one feed in, six runs out.
- Works with both 12V DC and 24V DC CCTV power supplies.
- Lever clamp termination — push the conductor in and close the lever; no crimping tool or screwdriver needed.
- Colour-coded channels keep positive and negative runs separate, so polarity stays consistent across all six outputs.
- Transparent housing lets you check each conductor is properly seated before you close up the enclosure.
- Accepts solid and stranded copper conductors, covering most CCTV power cable and alarm wiring.
Where it fits
Use it inside a CCTV power distribution box, camera junction box, or structured cabling enclosure — anywhere one power feed needs to branch out to multiple cameras. It's a wiring accessory, not a power supply itself, so you'll still need a PSU rated for your total camera load feeding into it.
Before you buy
Check your cameras run on 12V DC or 24V DC — this connector doesn't convert voltage, it only distributes it. Also confirm your PSU has enough spare capacity for six devices before wiring them all through one block.
Specifications
- Voltage
- 12V
- Colour
- Transparent
Frequently Asked Questions
Does this connector change the voltage?
No, it only distributes the incoming feed — it works with 12V DC or 24V DC, but doesn't convert between them.
Do I need any tools to wire it up?
No, it uses lever clamp termination — you insert the conductor and close the lever, no crimping or screwdriver required.
What cable types does it accept?
It accepts both solid and stranded copper conductors, which covers most CCTV power cable and alarm wiring.
Where would I fit this in a CCTV install?
It's designed to sit inside a power distribution box, camera junction box, or structured cabling enclosure where one feed needs to branch to multiple cameras.
